Instructions / Assembly
3 | P a g e
DO NOT overtighten self-tapping screws. They will strip the holes.
Moduline Select Series cabinets are assembled quickly and easily with self-tapping screws. Start your driver on a low clutch
setting and increase it as necessary until screws install properly. Batte hage affets ou die’s poe, so ake sue to
reset your clutch each time you change batteries.
If a hole does strip, replace the screw with a #10 nut and bolt (not provided).
TOOL BOXES
Tool boxes are shipped fully assembled.
To access the mounting holes you need to remove the drawers. With
a drawer fully open, hold down the release levers located on the inside
of both slides (see right) and pull the drawer out of the tool box. Set
the drawers aside, out of the way, and reinsert them once installation
is complete.
OVERHEAD CABINETS
Overhead cabinets are shipped fully assembled.
BASE CABINETS
Base cabinets require some assembly. Peel back protective vinyl from contact surfaces as you go.
For ease of access to mounting holes, cabinets are assembled upside-down and flipped once finished.
Assembly Steps:
1. Stand the door assembly
upside-down on its flat
top. Attach both sides
with (2) ¼-20 bolts [D] to
help temporarily align the
mounting holes while
driving in the self-tapping
screws. Fasten each side
with (4) 10-24 self-
tapping screws [B], then
remove the bolts.
D
B