Instructions / Assembly

8 | P a g e

One bracket has a pre-formed Z shaped end as shown. This end will fit inside the Insta-Wall channel.

Bend the other end at the desied legth. Fo spaes of  o oe ou ill eed to olt two brackets

together.

Install the brackets in the top hole of the Insta-wall using (1) ¼-20 bolt [E]. Locate them at least two

sections (2’) i fo the eds so the’e concealed. Use as many brackets as is necessary to adequately

secure your cabinets to the wall. Fasten the bracket to the wall using appropriate fasteners. Due to the

uniqueness of each installation, Moduline does not provide mounting hardware.

INSTALLING YOUR CABINETS

Attach your cabinets to the Insta-Wall with ¼-20 bolts [E]. Start with a closet, then the bases and tool

boxes, then install the countertop, then the overhead cabinets, and finally install the other closet.

Bolt neighboring cabinets together as you go. Mounting holes are pre-

punched, but you’ll eed to transfer one front hole from base

cabinets, tool boxes or overheads to any adjacent closet.

Chek that eah aiet is leel as it’s istalled. “hi

as necessary using the supplied horseshoe shims.

Loosen the toe kick and insert shims between it and

the cabinet until level. Bolting the cabinets together

can pull them out of square, so you may need to

adjust the shims at the end. It’s a good idea to shim

the cabinets so that they tilt slightly back, especially if

ou ae’t ahoig the to a all.

Use masking tape to cover areas that could get scratched during assembly.