Installation Guide

5 | P a g e

DO NOT overtighten self-tapping screws. They will strip the holes.

Moduline Select Series cabinets are assembled quickly and easily with self-tapping screws. Start your driver on a low clutch

settig ad iease it as eessa util ses istall popel. Batte hage affets ou die’s poe, so ake sue to

reset your clutch each time you change batteries.

If a hole does strip, replace the screw with a #10 nut and bolt (not provided).

CLOSETS

Closets require some assembly. Peel back protective vinyl from contact surfaces as you go.

For ease of access to mounting holes, cabinets are assembled upside-down and flipped once finished.

Assembly Steps:

1. Stand the door assembly upside-down on its flat top. Attach both sides with (3) ¼-20 bolts [D] to help

temporarily align the mounting holes while driving in the self-tapping screws. Fasten each side with

(6) 10-24 self-tapping screws [B], then remove the bolts.