Use Instructions

Table 9. Electromagnetic emissions – ML6710i device.
Emission tests Compliance Electromagnetic environment – guidance
RF emissions CISPR 11 Group 1 Class A
The laser system uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
Harmonic emissions
IEC 61000-3-2
Complies
Voltage fluctuations/flicker emissions
IEC 61000-3-3
Complies
CAN ICES-3 (A)/NMB-3(A) (Canada)
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
In order to comply with FCC / ISED RF Exposure requirements, this device must be
installed to provide at least 2 cm separation from the human body at all times.
This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference
that may cause undesired operation of the device.
Afin de se conformer aux exigences d’exposition RF FCC / ISED, cet appareil doit être
installé pour fournir au moins 2 cm de séparation du corps humain en tout temps
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
3. l’appareil ne doit pas produire de brouillage;
4. l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
Revision 9
55Guidance and manufacturer’s declaration – electromagnetic emissions