Use Instructions

6. Guidance and manufacturer’s declaration – electromagnetic
emissions
In order to prevent adverse events to the patient and yourself due to electromagnetic
disturbances, please make sure all equipment in the room where this device is
used are compliant with prevalent electromagnetic compatibility (EMC) standards
and regulations and that the supply mains is suitable for this device.
Use of accessories, transducers and cables other than those specified or provided by the
manufacturer of this equipment could result in increased electromagnetic emissions or
decreased electromagnetic immunity of this equipment and result in improper operation.
Portable RF communications equipment (including peripherals such as antenna
cables and external antennas) should be used no closer than 30 cm (12 inches)
to any part of the ML6710i, including cables specified by the manufacturer.
Otherwise, degradation of the performance of this equipment could result.
The emissions characteristics of this equipment make it suitable for use in industrial
areas and hospitals (CISPR 11 class A). If it is used in a residential environment (for
which CISPR 11 class B is normally required) this equipment might not offer adequate
protection to radio-frequency communication services. The user might need to
take mitigation measures, such as relocating or re-orienting the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
MANDATORY
C A U T IO N
C A U T IO N
WARNING
WARNING
Guidance and manufacturer’s declaration — electromagnetic emissions
The ML6710i is intended for use in the electromagnetic environment specified below. The owner/
user of this device is responsible for assuring that it is used in such an environment.
In order to comply with FCC / ISED RF Exposure requirements, this device must be
installed to provide at least 2 cm separation from the human body at all times.
ML6710i Instructions For Use
54 Guidance and manufacturer’s declaration – electromagnetic emissions