Use Instructions

4.4.2 Preventive and periodic maintenance
The ML6710i will show and alert for an
approaching calibration/maintenance due date.
Please contact the manufacturer authorized
service personnel for ordering and scheduling
of the preventive maintenance to avoid
disabling of the calibration past-due device.
The device is disabled from use
after 30 days overdue.
The service life of ML6710i is
generally seven (7) years.
Figure 51. Adjustment of the spot location
horizontally by turning ML-SLA lower part.
Figure 52. Adjustment of the spot location
vertically by tilting the mirror with a
dial (highlighted with the circle).
4.4.3 Adjusting the SLA spot location
The SLA spot location can be adjusted
in XYZ directions i.e. in horizontal,
vertical and focal planes.
Figure 51 shows how the horizontal location of
the spot is adjusted by turning the lower part of
the SLA.
The vertical location of the spot can be
adjusted by turning the dial that tilts
the mirror, as shown in Figure 52.
The spot is focused by turning the wheel
located on the side of the lower part of the SLA
(Figure53). The re-focusing protocol in section
4.4.4 on page 65 must be followed. The working
area (distance between spot focus and SLA mirror
axis) is adjustable in the range 37.5–47.5 mm.
ML6710i Instructions For Use
48 Operating the laser device