Use Instructions

In order to reduce of damaging of the power
supply of the power cord by overstepping or
overrunning, they shall be placed so that they
are not on isles or on typical floor areas where
people or equipment move frequently. Should the
device e.g., be taken temporarily out of use, please
follow re-packing instructions in section 3.2.1.
Figure 12. Connecting the power supply cable to
the DC IN jack on the ML6710i rear panel.
Do not use other than the original power supply provided
with the device or specified by the manufacturer.
PROHIBITED
In case of worn-out electric power cord or other event possibly leading
to weakening of insulation and danger of electric shock, contact the
manufacturer for service and disable device from use.
WARNING
3.4.2 Connecting power supply to DC IN
Figure 11. Connecting the optical fiber of the SLA to the ML6710i rear panel.
The power supply’s DC cable is attached to
the DC IN inlet as presented in Figure 12.
ML6710i Instructions For Use
26 Product delivery package and installation