User's Manual
MLX
TM
Mobile Platform
Communication System
User’s Manual
Page 13 of 18
Hardware Installation and Specifications
MLX
TM
Mobile
Hub
The MLX
TM
Mobile Hub consists of a rugged case to support and base plate
made of cast aluminum, which has been anodized and enameled to provide
maximum protection from harsh environments. Its physical dimensions are
approximately 33.0 by 26.2 by 8.9 centimeters (13 by 10.3 by 3.5 inches), and it
weighs 4.7 kilograms (10.4 pounds).
The MLX
TM
Mobile Hub is installed inside the mining vehicle’s cab usually
mounted to the wall or on an upright bracket attached to the floor or rear dash.
Mounted to the wall Mounted on an upright bracket
Important note: The pictures are not showing the MLX
TM
Mobile Hub. The
device that is being showed is the MasterLink
®
Mobile hub as reference, since
both have the same mounting pattern.
MLX
TM
Mobile
Hub – Specifications
Required Supply Voltage +12 VDC ISOLATED
(11.0-14.0)
Provided by the MLX™
Power Subsystem
Over voltage Turn-Off 14.0-14.5 VDC Protected to 40V
Reverse Polarity Protection built in Protected to -40V
Operating System Windows XPe
Standard Base Model
Processor
Celeron 600MHz
Standard CF (Compact
Flash)
1GB
Standard SDRAM 1GB
PC Card Slot Type II
Mini-PCI Slot Type IIIA