User's Manual

302395 User’s Guide and Repeater Network Design Guide
28 February 2004
Lat: 114841260 Lon: 3895267816 Elev: 1000 Num Sats: 8 GPS Age: 19271
Parent IP: 172.19.254.118
Temp: 30.6 Voltage: 27.3
Reply from 172.19.250.25:
Lat: 114827520 Lon: 3895306156 Elev: 1018 Num Sats: 8 GPS Age: 19807
Parent IP: 172.19.254.124
Temp: 28.0 Voltage: 28.2
The default configuration is to use DHCP to get an IP address for these devices. If you do not have a
DHCP server, you must temporarily enable a server, then go to the DHCP assigned IP address of each
device and configure it with a static IP address. You can do this through the HTTP interface by entering
the IP address you find with the FindWAPM utility. In the above example of the FindWAPM output,
going to the WAPM at 172.19.250.26 would display the following screen: