5643053346

F
Manual - MODSTER SR100 Hurricane
www.modster.at 25
17. Adjust positions of the silicone rings on main boom and jib boom as shown in above picture.
18. Move Silicone Rings („SR“ for short) to appropriate position as shown in picture. If further rigging needed, ad-
just refering to below instruction:
18.1. Move SR1 to adjust main sail until it is appropriately tight, but leaving little bending angle for better sailing
ability. Normally if in strong wind environment it needs more bending room, in gentle wind environment it needs
less bending room.
18.2. Normally you don‘t need to move SR2, keep it in the position as shown in picture.
18.3. Move SR3 to adjust the main boom if it is too tight(move to boomvang direction) or too loose (move to SR2
direction), in order to keep the main boom in center position of the hull when sail stick is at lowest position.
18.4. Move SR4 to adjust jib sail until it is appropriately tight, but leaving little bending room so that it can sail.
Normally if in strong wind environment it needs more bending room, in gentle wind environment it needs less
bending room.