Instructions remote control/manual transmitter

www
www.modster.at
7
Bedienungsanleitung - User Manual Brushless Transmitter
Rotate the steering wheel
clockwise while holding the
trigger to turn right. If the
steering is not tight enough,
increase the travel volume by
torating the travel rate knob
clockwise till you reach the
desired amount.
Rotate the steering wheel
counter-clockwise while holding
the trigger to turn left. If the
steering is not tight enough,
increase the travel volume by
rotating the travel rate knob
clockwise till you reach the
desired amount.
Error Search of your transmitter
Problem Possible Cause Solution
The system is not
connected.
The receiver goes into
failsafe mode not
matching the distance
from the transmitter.
The receiver not
responding during
operation.
- Your transmitter and receiver are
too close.
- You are aroung metal objects.
The model selected is not the model
bound to.
- The model is not the bound one.
- Check the receiver antenna to
ensure it. Is not cut or damaged.
- Low battery voltage.
- Loose or damaged wires or
connectors between battery and
receiver.
- Take transmitter 1 to 3 meters away from
receiver.
- Try in an area with less metal around.
- Check the selected model and ensure you
are bound to the specic one.
- Rebind your transmitter and receiver.
- Replace the receiver and rebind to
transmitter.
- Make sure your receiver antenna is above
the vehicle and is in an antenna tube.
- Check the wires and connection between
the battery and receiver.
- Repair or replace wires and/or connectors.