Instructions remote control/manual transmitter

www
www.modster.at
6
Brushless Transmitter
Binding is the process of programming the receiver to recognize the GUID (Globally
Unique Identier) code of a single specic transmitter. When a receiver is bound to
a transmitter, the receiver will only respond to that specic transmitter. If you need
to rebind for any reason, please follow these steps:
1. With the transmitter switched OFF.
2. Power on the receiver, then turn on the transmitter within 5 seconds.
3. The receiver LED will ash for 3-8 seconds to bind automatically.
4. After the receiver LED stop ashing, it means the binding is done.
Pull the trigger towards the driver
for the boat to move forward.
When you upgrade to brushless
speed control with the reverse
function, pushing the throttle
trigger forward will make the
motor run in reverse and back
the vehicle up.
Push the trigger away from the
driver, will move the boat in the
reverse direction.
The proportional speed control
meand the farther you pull it the
faster the vehicle will go.
Release the trigger to stop.
Receiver Connection and Binding
How to Operate Your Vehicle
Bedienungsanleitung - User Manual