Manual

F
Manual MODSTER FOLD 4K
www.modster.at 21
Step 2: Press down the controller power
switch to turn on the power. The controller
will make one short beep sound and the
red LED will ash. To pair the si-gnals of the
vision drone and the controller, you must
RAISE the UP/DOWN lever on the controller
all the way to the top. And then LOWER it
to the bottom. It will make one short beep
sound. The next time you RAISE the UP/
DOWN lever the drone will lift into the air.
Step 3: Always turn o the
power switch of the drone
after ight
Step 4: Always turn the
controller o after ight
and remove all the batteries
if you leave it unused for a
long period of time.
When ying outdoors, press the ,,Speed button“ three times to set
the third speed.
1. Adjust the frequency.
2. Calibration
3. Start your ight.
Turn on the drone and remote control after the drone LED light blink
quickly. Push the left stick of the remote control to the highest point
and then pull to the lowest point. After the remote control send a „beep“
sound the frequency matching is nished and the drone LED light
becomes steady.
Push both controler sticks to the position as shown on the picture and
hold them for a few seconds. The lights on the drone will start to ash.
Now the drone is recoverd to its original factory settings and ready to y
again.
Step 5: Please remove the bat-
tery by pres-sing down the tap
on the battery and extract the
battery. The rst attempts could
be more sluggish then the next
ones.
The throttle stick to lowest point.
Power Switch
6. Match the Frequency
7. Auto Trim Function