5641746086

F
Manual
16 www.modster.at
Binding process of remote control and receiver:
The remote control should already be bound to the recei-
ver at the factory. You can always do the binding as follows:
• Transmitter and receiver controller unit must be switched o
• Receiver controller Switch unit on
• Switch on the transmitter within 5 seconds
• The LED on the receiver will now blink for 3-8 seconds
• When this LED stopped blinking, binding was successful
1. Insert 4 pieces mignon AA batteries* into the
transmitter and check polarity!
* not included
Pull switch up:
ON
Pull switch down:
OFF
LED steady light:
Battery ok
LED ashing:
Low battery
Antenne
LED Licht
To drive forwards slowly, pull the throttle lever gently. Accellerate by
pulling the lever further to you. Let the lever go to create a standstill.
To drive backwards slowly, push the throttle lever gently. Accellerate
by pushing the lever farther away. Let the lever go to create a stand-
still.
Move the steering wheel clockwise to drive right. Move the wheel
counter clockwise to drive left.