Instructions/manual Easy Trainer 600
F
Manual MODSTER Easy Trainer 600
www.modster.at 21
LED Light
Gyro Switch
ON/OFF
Trimmer
Elevator
Trimmer Rudder
Throttle
Elevator/Rudder
7. Transmitter
Binding is the process by which the receiver is programmed to recognize the GUID (Global Unique Identier) code of a particular sender.
When a receiver is connected to a transmitter, the receiver responds only to that one transmitter.
If for some reason it is necessary to re-bind, please follow these steps:
1. Turn o the transmitter. Throttle the control lever down to the lower position.
CAUTION: Keep the Gyro switch in the middle or novice position
CAUTION: Leave the aircraft in a quiet position for the gyro to be calculated.
2. Connect the battery to the aircraft and turn on the transmitter within 5 seconds.
3. The receiver LED indicator ashes for about 3-8 seconds to automatically connect.
4. When the receiver LED indicator stops ashing, the connection process is complete.
7.1 Binding Process
Follow the steps below if you are using normal use:
• Switch the transmitter rst
• Connect the battery with the aircraft
• The LED receiver indicator ashes for a few seconds
• Shift the throttle lever up to Max and then down to Min to unlock
• Now a normal use should be feasible
DANGER: DO NOT fulll these steps near persons or other property to avoid injury and to avoid damage.
CAUTION: Make sure that the transmitter is rst turned on and then connected to the battery. If you want to switch o the transmitter, make
sure that the battery is rst switched o or not connected.
LED Light
0 - away from you: gyro o
1 - middle: soft gyro
2 - towards you: strong gyro
One-key Return
Activation
One-key Return
Switch