Manual Speed ​​Controller Brushless 85A SBEC

F
F
Manual MODSTER ESC 85A SBC/AN-266688
www.modster.at
Important Warnings
• MODSTER and their re-sellers are not responsible for your use of this product, or damage or injury
you may cause or sustain as a result of it‘s usage.
• MODSTER controllers are for use by adults only.
• Always remove the propeller or pinion when working on a power system with the battery con-
nected.
• Never use battery packs that are known to overheat.
• Never use short circuit battery or motor terminals.
• Always use proper insulation material for cable insulation.
• Always use proper cable connectors.
• Do not exceed the number of cells or servos specied by the ESC.
• Install the ESC in a suitable location with adequate ventilation for cooling. This ESC has a built-in
over temperature cuto protection feature that will immediately cut power to the motor once
theESC temperature exceeds the 230 Deg F/ 110 Deg C high temperature limit.
• Never switch your transmitter OFF while the battery is connected to your ESC.
• Only connect your battery pack just before ying and do not leave your battery pack connected
after ying.
• Handle your model with extreme care once the battery is connected and keep away from the
propeller at all times. Never stand in-line or directly in front of any rotating parts.
• Always y at a designated ying site and abide by the rules and guidelines set by your ying club.
Wire Connection Diagram
1. The speed controller can be connected to the motor by soldering directly or with high quality con-
nectors. Always use new connectors, which should be soldered carefully to the cables and insulated
with heat shrink tube. The maximum length of the battery pack wires shall be within 6 inches.
MSG Online GMBH
Wirtschaftspark 9
A-8530 Deutschlandsberg
Initial Throttle Calibration
1. Turn on your radio and push throttle stick to its maximum position (100%).
2. Connect the battery pack to the ESC. Wait for about 2 seconds, the motor will beep four sets of two
quick beeps, pull throttle stick to its lowest position before these beeps end. You will hear a special
tone to conrm the lowest throttle endpoint.
3. Calibration is done, you are ready to use ESC.
Note: You only need to do this once as throttle range will be stored in the memory of the speed cont-
roller. You can reset the throttle range by repeating steps stated above.
MODSTER AIR ESCs are fully programmable, there are lots of features can be programmed or changed
via your radio, program card, PC interface.
If you need further information of how - to please log on our website “www.MODSTER.at” or
„www.der-schweighofer.at/a266688“ to download manual or related rmware APP to change anything
you want with your ESC. Thanks for purchasing a MODSTER product, enjoy you fun with your hobby!
Firmenbuch Graz FN315230Z • UID-NR. ATU 64361513
EVA-Partnernummer: 152216
ARA Lizenznummer: 17749 • GRS Nummer: 110072576
Interseroh Hersteller ID (EAR): 152204
WEE REG.-NR. DE 44576630
1SPHSBNNJOHJOTUSVDUJPOT
 4UBSUUIFQSPHSBNNJOHNPEF
4XJUDIPOZPVSSFNPUFDPOUSPMUISPUUMFTUJDLUP
$POOFDUUIFCBUUFSZ
8BJUTFDPOETUIFOZPVXJMMIFBSSBQJEEPVCMFCFFQT"GUFSUIBUZPVXJMMIFBSTJOHMFCFFQT
BTBTJHOUIBUUIFQSPHSBNNJOHNPEFJTBDUJWF
 4FMFDUJPOPGUIFQSPHSBNJUFNT
5IFQSPHSBNNJOHTUFQTBSFBSSBOHFEJOTFRVFODFTFBDIQSPHSBNNJOHQPJOUDPSSFTQPOETUPB
TFSJFTPGUPOFTUIBUBSFSFQFBUFEGPVSUJNFTEJGGFSFOUUPOFTBSFSFQFBUFEJOBMPPQ8IFOUIF
UPOFTFRVFODFPGUIFQSPHSBNJUFNUPCFDIBOHFETPVOETNPWFUIFUISPUUMFTUJDLUPUIFJEMF
QPTJUJPOUPTFMFDUUIJTQSPHSBNJUFN
 4FMFDUUIFTFUWBMVF
5IFWBMVFTJOUIFQSPHSBNJUFNBSFJOEJDBUFEBDPVTUJDBMMZCZCFFQT*GUIFWBMVFXIJDIOFFETUP
CFTFUJTSFBDIFETFMFDUUIJTWBMVFCZNPWJOHUIFUISPUUMFTUJDLTUP"TQFDJBMUPOFDPOGJSNT
UIFOFXTFUUJOH
 %JTDPOOFDUUIFCBUUFSZUPGJOJTIQSPHSBNNJOH
PROGRAM