Instructions/manual SR80 Vector Pro

Manual - Brushless Transmitter

www.modster.at 37

Throttle Trim

Receiver Connection and Binding

The throttle trim dial is used to adjust the

throttle trim when the throttle stick is released

(neutral position). This is typically used to adjust

the brakes. Rotating the dial causes the throttle

trim (the throttle position at rest) to be

changed.

Steering trim

Install Your Receiver

The steering trim dial is used to adjust the

steering trim when the wheel is centered.

Rotating the dial changes the steering trim

(the steering at rest position).

Normally, the steering trim is adjusted until the

vehicle tracks straight.

Install the Receiver in your vehicle using

douple-sided Velcro. This will hold the

receiver in place and help isolate it from

vibrations. Mount the antenna up and away

from the vehicle in an antenna tube. The

higher up the antenna is, the better signal it

will receive.

CAUTION: Dont cut the antenna.

Binding is the process of programming the receiver to recognize the GUID (Globally Unique

Identifer) code of a single speciﬁc transmitter. When a receiver is bound to a transmitter, the

receiver will only respond to that speciﬁc transmitter. If you need to rebind for any reason,

please follow these steps:

1. Switch the transmitter off.

2. Power on the receiver, then turn on the transmitter within 5 seconds.

3. The receiver LED will ﬂash for 3-8 seconds to bind automatically.

4. After the receiver LED stop ﬂashing, it means the binding is done.