Instructions/manual SR80 Vector Pro

F
Manual - SR80 Vector Pro
30 www.modster.at
Problem Possible Cause Solution
Boat tends to dive in
water or takes on water.
The boat hull is not completely
closed.
Dry out the boat and ensure
the hatch is fully closed.
Center of gravity is too far
forward.
Move batteries back into the
hull.
Trim tabs are angled incorrectly
on the back of the boat.
Angle each trim tap up a small
amount to lift the bow or down
to lower the bow.
Boat tends to turn in
only one direction.
Rudder or rudder trims are not
centered.
Repair rudder or adjust it and
rudder trims for straight
running while the control is at
a neutral position.
Vertical fins of trim tabs are
angled incorrectly.
Angle the fins a small amount
to the right or left so that the
boat goes straight when the
rudder is at a neutral position.
Rudder does not move.
Damaged Rudder, linkage or
servo.
Replace damaged parts and
adjust the transmitter.
Wire is damaged or connections
are loose.
Check them (connect or
replace when needed)
Transmitter is not bound correctly
or a incorrect boat was selected.
Rebind or select the correct
boat.
BEC of ESC is damaged. Replace ESC.
ESC is off. Switch on ESC.