Instructions/manual SR80 Vector Pro

F
Manual - SR80 Vector Pro
www.modster.at 29
To charge your lithium battery, use a charger that is compatible with your battery. Charging
the lithium battery using a non-compatible charger (such as NiCd or NiMH rechargeable bat-
tery chargers) or other non-compatible lithium battery chargers may damage the battery or
cause a fire, causing damage to property and / or personal injury.
CAUTION: Be sure to ensure proper polarization before connecting.
Troubleshooting Guide
Charging Instruction
Problem Possible Cause Solution
Boat does not respond
to throttle but to other
controls.
Throttle servo travel is lower than
100%.
Make sure throttle servo travel
is 100% or more.
Throttle channel is reserved. Reverse throttle channel.
Reduced runtime or
boat underpowered.
Boat battery level is low. Completely recharge battery.
Boat battery is damaged. Replace it & follow instructions.
Blocking or friction on shaft or
propeller.
Disassemble, lubricate and
correctly align parts.
Boat conditions may be too cold. Make sure the battery is warm.
Battery capacity may be too low
for conditions.
Replace battery.
Drive torque is too close.
Loosen coupling at shaft and
move shaft a little bit.
Too little lubrication in shaft. Fully lubricate shaft.
Something blocks the rudder or
the propeller.
Remove boat from the water
and obstacles.
Boat does not link to
transmitter after
binding.
Transmitter is too near to the boat
during linking process.
Move powered transmitter a
few feet away, disconnect and
reconnect the battery.
Boat or transmitter is too close to
a large metal object.
Move boat or transmitter away
from the large metal object.
Boat or transmitter battery
charge is too low.
Replace or charge the battery.
Transmitter is bound to another
boat.
Bind your boat again to the
transmitter.
ESC is switched off. Switch ESC on.