User Manual

8/13
3
4
STEP-BY-STEP ASSEMBLY:
STEP 3: Carefully tap small wooden dowels into place. Leave 1/2” of the dowels sticking
out. Insert H2 into panel F. Refer to page 6 on how to use the cam lock system. Ensure all
hardware pieces are properly tightened.
STEP 4: Carefully tap small wooden dowels into place. Leave 1/2” of the dowels sticking
out. Insert H2 into panel C. Refer to page 6 on how to use the cam lock system. Ensure all
hardware pieces are properly tightened. Make sure the bolts go through the pre-drilled holes
properly. Do not over tighten bolts.