Installation Guide

6
07
Preparing for standard mounting
Installing remote control receiver
1. Carefully push the canopy to the bottom of the mounting
bracket, make two sliding holes aligned to the two prominent
screws on the mounting bracket, and then turn clockwise until tight.
2. Push the canopy ring to the bottom of the canopy, slide the
inner holes aligned to the two prominent screws on the mounting
bracket again, and turn the canopy ring clockwise until tight.
1. Remove the mounting bracket from the canopy
by loosening the two canopy screws located in
the L shaped slots.
2. Remove and save the two canopy screws in the
round holes. This will enable you to remove the
mounting bracket.
Preparing for mounting
1. Loosen the two canopy screws located in the bottom of the
mounting bracket(L shaped slots), and turn the canopy
counterclockwise to remove the mounting bracket from canopy.
2. Remove and save the two canopy screws in the round holes.
08
1.Fastening the blade to the motor
1.Remove the six blade screws with spring washers ( AA )
from the fan motor assembly ( G ).
Attach the blade ( A ) to the fan motor assembly ( G )
using two blade screws.
2.Repeat this step for the remaining blade assemblies.
( A )
( AA )