Instructions / Assembly

ManualsBrandsModland ManualsChandeliersLight Pro 3-Light Bronze Chandelier With Ripple Glass Shades

Wire

strippers

Ladder

Safety

glasses

Electrical

tape

Phillips

screwdriver

PliersFlat blade

screwdriver

CAUTION

◆ Inspect the wire insulation for any cuts,

abrasions, or exposed copper that may have

resulted during shipping. If there is a defect

in the wire, do not attempt installation.

◆ Before starting installation of this ﬁxture or

removal of a previous ﬁxture, disconnect the

power by turning oﬀ the circuit breaker or by

removing the fuse at the fuse box.

Bulbs

(not included)

*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED

EXPLODED PARTS

HARDWARE INCLUDED

Mounting

Unit

Mounting Screws

Wire Nuts

Fixture

Glass ShadeCover

Cover

Nipple and Nut

Fixture

Finial

Fixture Finial

Mounting Unit

Mounting

Screws

Wire Nuts

Chain

Stem

Holders

Canopy

Screw Collar

Ring

Screw Collar

Ring

Glass Shade

INSTALLATION

STEP 1

Adjust arms to proper position.

STEP 3STEP 2

Use the mounting screws to attach

the mounting unit to the junction box.

1. Weave the ﬁxture wire and

ﬁxture ground wire through

the nipple and nut, cover and

ﬁxture ﬁnial.

2.Tighten the nipple and nut, cover

and ﬁxture ﬁnial into the ﬁxture.

Summary of content (2 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS CAUTION ◆ Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation. ◆ Before starting installation of this ﬁxture or removal of a previous ﬁxture, disconnect the power by turning oﬀ the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
ASSEMBLY INSTRUCTIONS (INSTALLATION) STEP 4 STEP 5 1 . Choose the length of the chain you need (Open the chain using a phillips screwdriver (not included) and pliers (not included). ) 2. Attach the end of the chain to the fixture finial. 1 . Pass the chain and the branch wires through the screw collar ring and canopy. 2. Attach the end of the chain to the mounting unit. 3. Feed the branch wires through the pipe nipple on the mounting unit.