Troubleshoot
Table Of Contents
- Troubleshooting HD Direct Spark Units
 - How to use this application
 - Table of contents
 - Definitions & Basic Operation
 - Flame Status - Yellow LED labeled “FLAME”
 - Heating Sequence of operation
 - End of Heating Sequence of operation
 - Call for heat – unit does nothing
 - Call for heat – unit does nothing
 - Call for heat – unit does nothing
 - Call for heat – unit does nothing
 - Call for heat – unit does nothing
 - Call for heat – unit does nothing
 - Troubleshooting flash codes
 - Troubleshooting flash codes
 - No flashes – Troubleshooting codes
 - One Flash - Troubleshooting codes
 - One Flash – No Power Exhauster
 - One Flash – Pressure switch Won’t close
 - Two flashes - Troubleshooting codes
 - Three Flashes - Troubleshooting codes
 - Three Flashes - Troubleshooting codes
 - Four Flashes - Troubleshooting codes
 - Four Flashes - Troubleshooting codes
 - Four Flashes - Troubleshooting codes
 - Four Flashes - Troubleshooting codes
 - Four Flashes - Troubleshooting codes
 - Four Flashes - Troubleshooting codes
 - Four Flashes - Troubleshooting codes
 - Four Flashes - Troubleshooting codes
 - Four Flashes - Troubleshooting codes
 - Four Flashes - Troubleshooting codes
 - Five Flashes - Troubleshooting codes
 - Six Flashes - Troubleshooting codes
 - Six Flashes - Troubleshooting codes
 - Six Flashes - Troubleshooting codes
 - Seven Flashes - Troubleshooting codes
 - Before REPLACING THE CONTROL BOARD
 - For additional help Installation & Service manual live operators
 - Slide Number 41
 
FOUR FLASHES - TROUBLESHOOTING CODES 
• In lockout from failed ignition or flame loss unit 
SPARKS and SHUTS DOWN within 10 seconds 
• Reversed Polarity 
• To check for reversed polarity. (1) Shut down all power 
to unit (2) Switch main incoming power lines (black and 
white) to unit. (3) Carefully turn main power back on to 
unit.  
• If issue is not resolved, shut off all power and return 
white and black wires to original positions.  
• More possible causes  
Back                     Start Over  










