Installation Guide

Optional – Fan Mount
a) Use a qualified electrician for rough
in during pergola construction. You
will need a loop of electrical wire
pulled into one of the rafters that
the fan mount will be attached to.
b) NOTE: The mount can be installed
anywhere from the top to the
bottom of the rafter. For more
head clearance with the fan,
install hangers towards the top
of the rafter. Ensure that you
leave enough room for the skirt
to slide over the rafter hanger.
c) Once height is determined, attach
rafter hangers horizontally with
fasteners labeled "fan mount."
d) Carefully drill through the
center hole in the rafter hanger
into the rafter to access the
loop of wire for the fan.
e) Pull wire through the hole
in the rafter hanger.
f) Measure the clearance
between the rafter hangers.
g) Cut aluminum and vinyl 2x6 piece
1
⁄
8
" shorter than the distance
between hanger plates, to ensure
enough room to fit the 2x6 into
place. Test fit the 2x6 between
the hangers, trim if necessary.
h) Once 2x6 is the proper length,
mark and drill a hole for the wire
to come through the 2x6.
i) Slide skirts over each end of the
2x6 and test fit the mount in place.
j) NOTE: The skirts must be turned
the correct way to fit properly
into the rafter hangers. If they
do not lock into place, covering
the hanger, try removing them
and flipping them 180 degrees.
k) Fish wire through and out
of the 2x6 carefully to avoid
damaging the sheath.
l) Fasten each end of the 2x6 with
fasteners labeled "fan mount."
m) Slide the skirts into place.
n) The mount is now ready for your fan.