Instruction Manual Vivitar Bluetooth Boombox Speaker
Contents Warnings and Precautions - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2 Important Safety and Instructions - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 4 Warnings - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5 Feature Controls - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 6,7 Getting Started / Main Operation - - - - - - - - - - -
Warnings and Precautions Caution: • TO PREVENT ELECTRIC SHOCK, FULLY INSERT THE PLUG INTO THE OUTLET, ENSURING THE WIDE PRONG IS IN THE CORRECT SLOT. • Use of any controls or adjustments or performance of procedures other than those herein specified may result in hazardous radiation exposure. • There is a danger of explosion if batteries are placed incorrectly. Warning: • To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. THIS UNIT MUST BE SERVICED BY QUALIFIED SERVICE PERSONNEL. The lighting flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
Important Safety Instructions 1. Please read, follow and keep these instructions and comply with all recommended cautions. 2. Do not use this unit near water. 3. Clean with a dry cloth only. 4. Do not block ventilation openings. 5. Do not place the unit near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 6. Follow safety precautions and use a polarized or grounded-type plug.
FCC Warnings Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Feature Controls 7 8 1 2 3 9 POWER 10 4 11 5 12 6 13 14 15 16 19 17 18 19 20 21 22 6
Feature Controls 1. AUX-In Jack (Line in) 2. Power Button 3. Tune+ or /Tune- Button 4. Play/Pause/Pair Button 5. Stop/M+ (Memory Up) Button 6. X-BASS Button 7. FM Antenna Rod 8. Carrying Handle 9. Repeat Button 10. MEM/PROG Button 11. Source Button 12. Volume Buttons 13. CD Open Button 14. Cassette Pause Button 15. Cassette Stop/Eject Button 16. Cassette F.FWD/REW Button 17. Cassette Play Button 18. Cassette Rec Button 19. Speakers 20. LCD Display 21. DC in (DC-6v) 22.
Getting Started / Main Operation Power On the Unit: Press the Power button to turn the unit on or off. Adjusting the Volume: Press the Volume buttons to increase or decrease the volume level. Adjusting the Antenna Rod: The antenna should be extended to ensure good reception. It may be necessary to alter the position of the unit and/or antenna to achieve the best signal. Using Headphones: This unit can support up to 6 headphones connected together.
AC Operation: Use the 6V adapter (included) by connecting the small end of adapter cable into the DC hack at the rear of the unit. Insert the adapter plug into a conveniently-located AC outlet. Please ensure that your mains supply is compatible before use. Listening to the Radio Using the Radio: 1. Press the Source button to select FM mode. 2. The LCD Display will show the frequency of the radio. Automatic Radio Tuning: 1. In FM mode, press the /Tune+ or /Tune- to manually scan through the frequency band.
Listening to CDs Insert a CD: 1. Open the CD door by pressing the Open button. 2. Insert a disc into the disc compartment with the title side up. 3. Close the CD compartment door. Removing a CD: Press the Stop/M+ button once, open the CD door by pressing Open button. Remove the CD when it has stopped spinning. Playing a CD: 1. Press the Source button to select CD mode. 2.
Using Repeat Function: 1. Press the Repeat button once to repeat current track playing. 2. Press the Repeat button twice to repeat all tracks on the CD. 3. To cancel the repeat function, press the Repeat button until “1 or ALL” icons disappear or press the Stop/M+ button. Using a Bluetooth® Device This unit can connect to any Bluetooth ®-enabled device by following the steps below. Setup Your Unit on Bluetooth® (bt) Mode: 1. Press the Source button to select (bt) mode. 2.
Playing Audio Via Bluetooth®: 1. When Bluetooth ® has been successfully paired, press the Play/Pause/ Pair button to play or pause music from your unit. 2. Press /Tune+ /Tune- or button to jump to next/previous music track. 3. Music can also be controlled from the Bluetooth ®-enabled device. Incoming Call: The volume of the music will automatically lower when you have an incoming call. When the call is complete, the music will resume at the original set volume. Using AUX-In (line in) Requires a 3.
Playing Cassettes: Press the Source button to select Tape mode. When the Tape mode is selected, “TAP” will appear on the LCD display. Insert the cassette tape and press the PLAY button. The unit will automatically stop playing when it has reached the end of the cassette. If you wish to continue playing the cassette; please press Stop/Eject, remove the cassette, flip the cassette over to the other side, reinsert the cassette and press Play. 5. Press the Stop/Eject button to stop the tape.
• • • • • • • • • • • • • Bluetooth® Adapter AC Input: AC100-240V~50/60Hz Adapter DC Output: DC 6V 1.2A Batteries Power: DC 12V (8x1.5V) “C” size UM-2/LR14 Batteries Output Power: 2 x 2 Watts Speaker: 76mm (3”) Cone Type AUX-In: 3.5mm Jack Headphone: 3.5mm x 6 Dimensions: 13.39” L x 10.24” D x 5.31” H Weight: 5.07 lbs.
