Specification

Modern Masters
Revised May 2011
Page 2 of 2
Taping – Use high quality, low-tack tape when taping
over surfaces that have been previously painted.
Dry Times – Recoat time is approximately ½ hour. Dry
time is approximately 12 hours. It is important that Metal
Effects Primer is completely dry before applying Metal
Effects Reactive Metallic Paint. (Drying times were
recorded at 70°F and 50%RH): Note: Lower
temperature and/or higher humidity will lengthen the dry
and cure times.
Coverage – One gallon/3.78 liters will cover
approximately 320 square feet/29.7 square meters.
Approximately 1.5 mils dry film thickness per coat. A
minimum of 3 mils dry film thickness is required.
Clean Up – Clean brushes, rollers, tool, and equipment
with soap and warm water immediately after use. Do
not reuse containers and properly dispose of empty
containers.
VOC – Metal Effects Primer contains less than 100 g/L.
Handling & Storage – Close tightly all containers when
not in use. Store in a cool dry place away from direct
sunlight. Do not freeze. If Metal Effects Primer
becomes frozen, allow to completely thaw and come to
room temperature before use. Stir thoroughly before
use.
Disposal – Dispose of unused or unwanted product in
accordance with local laws regulating water-based
coatings.
Health & Safety – Overexposure can cause lung and
kidney damage. Cancer hazard. Contains crystalline
silica which can cause cancer. (Risk of cancer depends
on level of exposure). Use in a well-ventilated area.
Avoid contact with eyes. Wash hands thoroughly with
soap and warm water after use. Do not take internally.
When spraying or sanding, use a properly-fitting,
NIOSH approved respirator per the manufacturer’s
instructions. Warning! If you scrape, sand, or remove
old paint, you may release lead dust. LEAD IS
TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE
SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE,
ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-
approved respirator to control lead exposure. Clean up
carefully with a HEPA vacuum and a wet mop. Before
you start, find out how to protect yourself and
your family by contacting the National Lead Information
Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead
Skin contact: Thoroughly wash with soap and warm
water before the coating dries. Individuals with sensitive
skin may require gloves.
Eye contact: Rinse with clean water for 15 minutes.
Seek medical attention.
Inhalation: To help prevent irritation, use only in well-
ventilated areas. If irritation occurs, move to fresh air.
If irritation persists, seek medical attention.
Ingestion: Do not induce vomiting. Seek medical
attention.
Read the Material Safety Data Sheet for Additional
Health and Safety Information.
Warranty – This product will perform as claimed if
directions are followed. Directions are as complete as
possible, but cannot encompass all conditions,
applications, techniques, and/or surfaces, which are
beyond our control. Warranty is limited to replacement
or refund value of product actually used, if such product
proves defective within two years of manufacture. No
other warranty is expressed or implied.
Technical Assistance – For additional technical
assistance contact our Technical Department at
818-683-0201 or e-mail [e-mail].
Disclaimer: Modern Masters, Inc. believes, to the
best of its knowledge, information, and belief, the
information contained herein to be accurate and reliable
as of the date of this material safety data sheet.
However, because the conditions of handling, use, and
storage of these materials are beyond our control we
assume no responsibility or liability for personal injury or
property damage incurred by the use of these materials
and makes no warranty, expressed or implied,
regarding the accuracy or reliability of the data or
results obtained.
Container Size Container Weight Under
1 four ounce .5 lbs.
1 Pint 1.5 lbs.
1 Gallon 11.5 lbs.