Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
746 - Outdoor Wall Sconce
WS-W74612/WS-74615
FIG.1PREPARATION
1. Shut o the power at the circuit breaker and remove existing x-
ture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a
clear area. Be careful not to lose any small parts necessary for
installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (C1) and gasket (D1) from the mount-
ing plate.
4. Secure the mounting plate to the junction box using junction box
screws (B1).The side of the mounting back plate marked
“GND” must face out.
CONNECTING THE WIRES (Fig. 2)
5. Connect the xture wires to junction box wires as shown in Fig. 2,
making sure that all wire connectors (A1) are secured. If your outlet
box has a green or bare copper ground wire, connect the xture’s
ground wire to it. Otherwise, connect the xture’s ground wire di-
rectly to the back plate using the green screw provided. After wires
are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
6. Place the glass to the top ring, and secure it with the bottom ring
by using two screws (E1) on the bottom.
7. Place the xture on the mounting plate, and secure it with mount-
ing screw (C1) and gasket (D1).
8. To prevent moisture from entering the outlet box and causing a
short, use clear caulking (i.e. indoor/outdoor silicone sealant) to
outline the outside of xture back plate where it meets the wall.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Back Plate Dimensions
B1
A1
C1
D1
E1
Junction Box Screw
Fixture
Wire Connector
Mounting Screw
Mounting Plate
Junction Box
Gasket
Screw
Top Ring
Glass
Bottom Ring
G
N
D
4”
1 3/4”
1 3/8”
4 1/4”
Junction Box
Caulking
Fig. 3 Sealing