Installation Guide

2
INSTALLATION INSTRUCTIONS
719-Outdoor Wall Sconce
WS-W71918/WS-W71928/WS-W71918F/WS-W71928F
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Fig. 1
Fig. 3
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous impro
vement program. Feb 2019
JANUARY, 2017
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to
lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (E) and gasket (F) from the fixture.
4. Drill a hole in the wall aligned with the key-hole located in the mounting plate, insert the plastic anchor (B).
5. Secure back plate to the junction box using the screws provided with the junction box. Fasten the mounting plate to
the wall using the
wood screw (C).
NOTE: The side of the mounting back plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
6. Connect the fixture wires to junction box wires as shown (Fig. 2). Make sure that all wire connectors (A) are secure. If your outlet box
has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the
back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
COMPLETING THE INSTALLATION
7. Secure the metal frame to fixture back plate with set screw (D).
8. Place the fixture on the mounting plate, and secure it with
mounting screw (E) and gasket (F).
9. To prevent moisture from entering the outlet box and causing
a short, use clear caulking (i.e. indoor/outdoor silicone sealant)
to outline the outside of fixture back plate where it meets the
wall. Leave a space at the bottom to allow moisture to escape
(Fig.3).
Junction Box
Caulking
Back Plate Dimensions
A
Wire Connector
Junction Box
B
Junction Box Screw
C
Plastic Anchor
D
Wood Screw
E
Set Screw
Mounting Screw
Gasket
Metal Frame
F
Outer Glass
(RPL-GLA-71918-01/
RPL-GLA-71928-01)
Inner Glass
(RPL-GLA-71918-02/
RPL-GLA-71928-02)
WS-W71928
26 1/2"
WS-W71918
17"
4 1/2”
Ø 2 3/4"
Ø3 1/2”