Installation Sheet

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
696 - LED Outdoor
WS-W69628
FIG.1
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (C1) and gasket (D1) from the mounting back plate.
4. Drill a hole in the wall aligned with the key holes located in the mounting plate, insert the plastic anchor (E1) to the wall.
5. Secure the mounting plate to the junction box using junction box screws (B1), fasten it to the wall using the wood screw (F1).
The side of the mounting back plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
6. Connect the xture wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
7. Place the xture on the mounting plate,
and secure it with mounting screw (C1)
and gasket (D1).
8. To prevent moisture from entering the
outlet box and causing a short, use clear
caulking (i.e. indoor/outdoor silicone sealant)
to outline the outside of xture back plate
where it meets the wall. Leave a space at the
bottom to allow moisture to escape Fig. 3.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Back Plate Dimensions
Junction Box
Caulking
Fig. 3 Sealing
A1
B1
E1
F1
C1
D1
Wire Connector
Junction Box
Mounting Plate
Fixture
Junction Box Screw
Plastic Anchor
Wood Screw
Mounting
Screw
Gasket
Ground Wire
Ground Screw
4 1/4”
7 1/8”
1 3/8”
1 3/4”