Installation Sheet
Table Of Contents
1. Shut o the power at the circuit breaker and remove existing xture,
including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear
area. Be careful not to lose any small parts necessary for installation.
3. Remove the mounting screw (B) and back plate from the xture. Drill
holes in the wall aligned with the key hole located in the mounting plate,
insert the plastic anchor(E).
4. Secure the mounting back plate to the junction box using standard
junction box screws that comes with the junction box. Fasten it to the
wall using wood screw (D).
5. Connect the driver’s input wires to junction box wires as shown in (Fig. 2),
making sure that all wire connectors (A) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground
wire to it. Otherwise, connect the xture’s ground wire directly to the
back plate using the screw provided. After wires are connected,
tuck them carefully inside the junction box.
.
2
Phone (800) 526.2588
Fax (800) 526.2585
44 Harbor Park Drive
Port Washington, NY 11050
1600 Distribution Ct
Lithia Springs, GA 30122
1750 Archibald Avenue
Ontario, CA 91760
9
5
8
"
6
3
8
"
1
3
4
"
4
1
4
"
1
3
8
"
Junction Box
Caulking
Driver 5 3/8"LX
2 1/2"WX 1/2"H
Back Plate
Plastic Anchor
E
A
B
Mounting
Screw
Wood Screw
D
Junction Box
Screw
Wire
Connector
Ground Wire
Junction Box
6. Secure the xture to the mounting back plate using the mounting screw (B) and
rubber gasket
(C).
7. To prevent moisture from entering the outlet box and causing a short circuit,use clear caulking (i.e. indoor/outdoor silicone sealant) to
outline the outside of xture back plate where it meets the wall,Leave a space at the bottom to allow moisture to escape(Fig.5).
Fixture
Rubber
Gasket
C
INSTALLATION INSTRUCTION
WS-W64824
Black or
Smooth
White or
Ribbed
Bare wire
(Ground)
Black
(Hot)
White
(Neutral)
Green or Bare Copper
(Ground)
8 . This xture features electronic low voltage (ELV or TRAIC) or 0-10V dimming capabilities. See notes below for specic dimming wires information.
9. To utilize ELV or TRAIC dimming: use wires black (hot), white (neutral) and green ground wire (ground).
10. To utilize 0-10V dimming: use wire purple (dim+), grey (dim-), black (hot), white (neutral) and green ground wire (ground).
NOTE: Make sure to connect 0-10V prior to power-up the xture in order to allow the 0-10V dimming to function properly.
Purple - Dim+
Grey - Dim-
Black - Hot
White - Neutral
Red - Fixtrue+
Black - Fixtrue-