Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
PREPARATION
Shut o the power at the circuit breaker and remove existing
xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out
all the parts on a clear area. Be careful not to lose any
small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Secure the mounting plate (E1) to the junction box
(F1) using junction box screws (A1). The side of
the mounting plate marked “GND” must face out.
4. Adjust the screw (J1) length to t the ball nut (I1).
CONNECTING THE WIRES (Fig. 2)
5. At this point, connect the electrical wires as shown in Fig. 2.
Make sure that all wire connectors (B1) are secured. If your
outlet box has a ground wire (green or bare copper),
connect the xture’s ground wire to it. Otherwise,
connect the xture’s ground wire directly to the mounting
plate (E1) using the green screw provided. After wires are
connected, tuck them carefully inside the junction box.
6. Slide the glass (H1) into the xture bottom from back.
7. Put the xture (K1) onto the mounting plate (E1) and secure
with ball nuts (I1).
8. Slide the glass (G1) into the channels on the xture front.
Insert the glass (M1) into the xture frame.
9. Place the top cover (L1) onto the plastic sheet (N1)
and the xture. Secure it with gaskets (D1) and screws (C1).
COMPLETING THIS INSTALLATION (Fig. 3)
10. To prevent moisture from entering the outlet box and
causing causing a short, use clear caulking (i.e. indoor/outdoor
silicone sealant) to outline the outside of xture back plate
where it meets the wall. Leave a space at the bottom to allow
moisture to escape (Fig.3).
INSTALLATION INSTRUCTION
Elevation
WS-W5216, WS-W5222
FIG.1
J1
H1
I1
K1
G1
M1
L1
C1
D1
N1
A1E1
B1
F1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
Junction Box
Caulking
Fig.3 Sealing