Installation Guide

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JAN 2019 2
Fig.1
Fixture W
ires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
PREPARATION
-
Shut off the power at the circuit breaker and remove existing fixture, including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for
installation.
MOUNTING THE FIXTURE (FIG. 1)
1. Position the mounting plate (B1) on the wall, mark the location of the key hole. Pre-drill the holes for plastic anchors (M1) and
insert the plastic anchors (M1) into the wall.
2. Insert the wood screw (J1) into the plastic anchors (M1) from the key hole (A1) leaving enough length to hang the mounting
plate (B1). Tighten mounting plate (B1) to the wall.
3. Attach ring to back plate with screw (G1), put glass onto fixture and secure with the glass holder (F1) and screw (E1).
NOTE: Ring with sharp edge should face down. Caulk screw (G1) using silicone for wet location.
4. Secure the mounting plate (B1) to the junction box using junction box screws (K1).
NOTE: The side of the mounting plate marked "GND" must face out.
CONNECTING THE WIRES (FIG. 2)
5. Make sure that all wire connectors (L1) are secure. If your outlet box has a green or bare copper ground wire, connect the
fixture’s ground wire to it. Otherwise. Connect the fixture’s ground wire directly to the back plate using the green/ ground screw
(C1) provided. After wires are connected. Tuck them carefully inside the junction box.
6. Place the fixture onto the mounting plate (B1) and secure with mounting screws (H1) and gasket (I1).
COMPLETING THE INSTALLATION (FIG. 3)
7. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant)
to outline the outside of fixture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape (Fig.3)
.
Junction Box
Caulking
Fig.3 Sealing
E1
F1
G1
H1
I1
J1
K1
L1
M1
A1
B1
C1
Screw
Glass
Holder
Glass
Ring
Junction
Box
Key Hole
Mounting Plate
Ground
Screw
Junction
Box Screw
Gasket
Mounting
Screw
Screw
Wood
Screw
Plastic
Anchor
Wire
Connector
INSTALLATION INSTRUCTIONS
Vitrine - Exterior
WS-W32512, WS-W32516,WS-W32521
Technology Upgraded
No Dr
iver Required
Driver
(Please direct wir
e with 120V AC)