Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JUNE, 2015 2
INSTALLATION INSTRUCTION
Rain - Outdoor
WS-W2408
PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
- Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (FIG. 2)
1. Remove mounting screws (C1) and gasket (D1)
2. Connect the Fixture wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. Fixture and
junction box ground wires should be connected to mounting plate using green screw provided. Tuck wires carefully inside the junction box.
COMPLETING THE INSTALLATION (FIG. 3)
3. Secure mounting back plate to the junction box using junction box screws (B1). The side of the mounting back plate marked “GND” must
face out.
4. Place the xture over the mounting back plate and secure with screws (C1) and gasket (D1).
5. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of xture back plate where it meets the wall. Leave a space at bottom to allow moisture to escape.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2
Fig. 1
A1
B1
D1
C1
D1
C1
Wire
Connector
Junction Box
Ground Wire
Junction Box Screw
Ground Wire Screw
Mounting Plate
Mounting Screw
Gasket
Glass
Cover Board
Gasket
Mounting Screw
Junction Box
Caulking
Fig.3 Sealing