Installation Guide

Fig.1
PREPARATION
1. Shut off the power at the circuit breaker and remove existing
fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on
a clear area. Be careful not to lose any small parts necessary
for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Secure mounting backplate (DD) to the junction box (FF)
using junction box screws (BB). The side of the mounting
backplate marked “GND” (EE) must face out. *Requires
Transformer to be recessed within the junction box
CONNECTING THE WIRES (Fig. 2)
4. Connect the electrical wires as shown in Fig. 2, making sure
that all wire connectors (AA) are secured. If your outlet box
has a ground wire, connect it the fixture’s ground wire.
Otherwise, connect the fixture’s ground wire directly to the
backplate (DD) using the green screw (EE) provided. Tuck
wires carefully inside the junction box.
5. Place the fixture over the mounting backplate (DD) and
secure with screws (CC) and gasket (GG).
Fig. 2
COMPLETING THE INSTALLATION (Fig. 3)
6. To prevent moisture from entering the outlet
box and causing a short, use clear caulking
(i.e. indoor/outdoor silicone sealant) to outline
the outside of fixture back plate where it meets
the wall. Leave space at the bottom to allow
moisture a means to escape (Fig. 3).
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper
(Ground)