Installation Guide

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. DECEMBER, 2014 2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation
MOUNTING THE FIXTURE (FIG. 1)
1. Drill holes in the proper position on the wall according to the keyholes located on the mounting plate (D1). Insert the plastic anchors (I1)
into the wall.
2. Secure the mounting plate (D1) to the junction box (A1) using the junction box screws (B1). Fasten mounting plate (D1) to the wall using the
wood screws (J1). The side of the mounting plate marked “GND” must face out.
3. Lock the metal hook (M1) of the safety cable onto the mounting plate.
CONNECTING THE WIRES
4. Connect the xture wires to supply wires as shown in Fig. 2, making sure that all wire connectors (C1) are secured. If your outlet box has
a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
mounting plate (D1) using the green screw provided. After wires are connected, tuck them carefully inside the junction box (A1).
MOUNTING THE FIXTURE (FIG. 1)
5. Place the xture frame (G1) over the mounting plate (D1) and secure with set screws (E1)two at the bottom, two at the top and gasket (F1).
6. Put the glass (K1) in the xture frame (G1) from the top and put the metal frame (H1) on the glass (K1) secure it to the mounting plate (D1)
with screws (E1) and gasket (F1).
COMPLETING THE INSTALLATION
7. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of xture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape Fig.3
Junction Box
Caulking
Fig.3 Sealing
M1
J1
I1
C1
B1
D1
F1
E1
G1
H1
E1 F1
Junction Box Screw
Wire Connector
Anchor
Mounting Plate
Gasket
Fixture Screw
Metal Hook
Junction Box
Fixture Frame
Wood Screw
Fixture Screw, Gasket
Metal Frame
Glass
Fig.1
INSTALLATION INSTRUCTION
Kyoto - Exterior
WS-W22520