Installation Guide

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. DECEMBER, 2014 2
INSTALLATION INSTRUCTION
Kyoto - Exterior
WS-W22510
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES
1. Secure the mounting plate (D1) to the junction box using the junction box screws (B1).
The side of the mounting plate marked “GND” must face out.
2. Connect the xture wires to suppy wires as shown in Fig. 1, Fig. 2, making sure that all wire connectors (C1) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
mounting plate (D1) using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (FIG. 1)
3. Place the xture back plate over the mounting plate (D1) and
secure with mounting screws (E1) and gaskets (F1).
4. Put the glass on the xture from the top and put the metal frame (H1)
on the glass and secure it to the mounting plate with screw (E1)
and gasket (F1).
Fig.1
H1
E1 F1
B1
C1
D1
F1
E1
Junction Box
Wire Connector
Mounting Plate
Gasket
Fixture Screw
Junction Box Screw
Glass
Metal Frame
Fixture Screw, Gasket