Installation Sheet

2
INSTALLATION INSTRUCTIONS

WS-W18122
.+*
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
.+*/  )


Phone [phone]
Fax [phone]

44 Harbor Park Drive
Port Washington, NY 11050

1600 Distribution Ct
Lithia Springs, GA 30122

1750 Archibald Avenue
Ontario, CA 91760
00
1. Shut o the power at the circuit breaker and remove
existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small
parts necessary for installation.
,+.12. )*3
3. Remove the mounting screw (B) and silicone Gasket (C) from the canopy.
4. The lamp can switch between three color temperatures (3000k-3500k-4000k), which
can be adjusted to your preference with the switch in the canopy (Fig.4).
5. Secure the mounting back plate to the junction box using standard
junction box screws that comes with the junction box.
Note: (i)using any other non-original- manufacturer Provided junction
box screw may result in safety issue;
(ii) The side of the mounting plate marked “GND” must face out.
+2. )*/3
6. Connect the xture’s wires to junction box wires as shown in Fig. 2,
making sure that all wire connectors (A) are secured. If your outlet
box has a green or bare copper ground wire, connect the xture’s
ground wire to it. Otherwise, connect the xture’s ground wire
directly to the back plate using the GND screw provided. After wires are
connected,tuck them carefully inside the junction box.
,04+44
7. Secure the xture to the mounting back plate using the mounting
screw (B) and silicone gasket (C).
8. To prevent moisture from entering the outlet box and causing a short,
use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of xture back plate where it meets the wall(Fig.3).
. )*5 )


Wire Connector
Mounting Screw
Lamp Body
Junction Box
A
B
Mounting back plate
Silicone gasket
C
Junction Box Screw
6#0 7! !
6
1
2
″
4
1 8
″
1
3 4
″
1
3
8
″
3500K4000K 3000K
. )*8