Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAY, 2015 2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2
Junction Box
Caulking
Fig.3 Sealing
INSTALLATION INSTRUCTION
Forq - Outdoor
WS-W1724
PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
- Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
1. Secure mounting back plate to the junction box using junction box screws (D1). The side of the mounting back plate marked “GND”
must face out.
CONNECTING THE WIRES (FIG. 2)
2. Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box has a ground wire,
connect it to the xture’s ground wire. Otherwise, connect the xture’s ground wire directly to the back plate using the green screw
provided. Tuck wires carefully inside the junction box.
3. Place the xture over the mounting back plate and secure with set screws (C1) and gasket (B1).
COMPLETING THE INSTALLATION (FIG. 3)
4. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant)to outline the
outside of xture back plate where it meets the wall leaving a space at bottom to allow moisture a means to escape.
Fig. 1
D1
C1
B1
A1
Junction Box Screw
Junction Box
Input Wires
Wire Connectors
Mounting Back Plate
Set Screw
Gasket