Installation Guide

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAY, 2015 2
INSTALLATION INSTRUCTION
Ledge - Outdoor
WS-W1412
Fig. 1
A1
B1
D1
I1
J1
L1
C1
N1
K1
H1
G1
M1
M1
Wire Connector
Junction Box
Transformer
Plastic Anchor
Mounting
Back Plate
Canopy Plate
Outer Glass
Rubber Gasket
Set Screw
Aluminum Frame
Knurled Nut
Inner Glass
Wood Screw
Junction Box Screw
PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
- Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
1. Remove set screws (C1) and rubber gasket (N1) from the xture.
2. Drill holes in the wall aligned with the key-hole location in mounting back plate (G1).Insert the plastic anchors (M1) into the wall.
CONNECTING THE WIRES (FIG. 2)
3. Connect the transformer input wires to junction box wires as show in Fig.2, making sure that all wire connectors (A1) are secured. If your
outlet box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire
directly to the back plate (G1) using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
*Requires transformer to be recessed within the junction box.
COMPLETING THE INSTALLATION (FIG. 3)
4. Secure the mounting plate (G1) to the junction box using the junction box screws (B1). Fasten mounting plate (G1) to the wall using the
wood screws (D1). The side of the mounting plate marked “GND” must face out.
5. Place canopy plate (H1) over mounting back plate (G1) and secure with knurled nuts (J1).
6. Fit the outer glass (K1) into the aluminum frame (L1) and place the frame over canopy plate (H1) and secure with screws (C1) and rubber
gaskets (N1)
7. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of xture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape (Fig.3).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2
Junction Box
Caulking
Fig.3 Sealing