Installation Sheet

Modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Ave
Ontario, CA 91761
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.

INSTALLATION INSTRUCTION
Out LED Vanities
WS-93027/WS-93037
Fig.1
Fig.2
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture.
2. Carefully unpack your new fixture and lay out all the parts in a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting plate(C) from the fixture
4. Secure the mounting plate to the junction box using junction box screws provided.
Note: The side of the mounting plate marked “GND” must face out.
5. Connect the fixture’s input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A)
are secured.If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly to the back plate using the green screw provided. After wires
are connected,tuck them carefully inside the junction box.
6. Secure the fixture to the mounting plate by pressing the fixture onto the mounting plate.
Fig.3