Installation Guide

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. DECEMBER, 2014 2
INSTALLATION INSTRUCTION
Quantum - Vanity
WS-41518
I1
H1
G1
B1
C1
D1
E1
F1
Junction Box
Screw
Metal Hook
Mounting
Plate
Set Screw
Input Wires
Junction Box
Wire Connector
Anchor
Wood Screw
Key hole
Assembly Screw
Crystal panel
Fig.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
1. Remove the set screws (G1) from the xture, secure the crystal panel to the xture back plate using assembly screws (E1).
2. Drill the holes in the proper position on the wall according to the keyholes located on the mounting back plate (H1).
Insert the plastic anchors (C1) into the wall.
3. Secure the mounting plate (H1) to the junction box (A1) using the junction box screws (I1). Fasten mounting plate (H1) to the wall using the
wood screws (D1). The side of the mounting plate marked “GND” must face out.
4. Lock the metal hook of the safety cable onto the mounting plate, This will allow the xture to be supported while connecting the wires.
CONNECTING THE WIRES
5. Connect the xture wires to supply wires as shown in Fig. 2, making sure
that all wire connectors (B1) are secured. If your outlet box has a green
or bare copper ground wire, connect the xture’s ground wire to it.
Otherwise, connect the xture’s ground wire directly to the mounting
plate (H1) using the green screw provided. After wires are connected,
tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (FIG. 1)
6. Place the xture over the mounting plate (H1) and secure
with set screws (G1).