Installation Sheet

5. Place the canopy on the fixture, put the red
and black power cord of the module through
the hole in the corner of the canopy and secure
the canopy on the fixture with thumb screws (D)
6. Connect the red and black line of IC components
with the red and black line of module with the
wire connector (B).
7. Drill holes in the wall aligned with the key holes located in the back plate, insert the plastic anchor (E).
8. Secure the back plate to the junction box using the screws provided with the junction box. Fasten it to the wall using wood screws (F).
NOTE: The sides of the mounting plate marked "GND" must be facing outward.
2
INSTALLATION INSTRUCTIONS
399- LED Vanities
WS-39920/WS-39927/WS-39938
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
FIG. 2 Wiring
FIG. 1
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous impro
vement program. Jan 2019
JANUARY, 2017
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut off the power at the circuit breaker
and remove existing fixture, including
the crossbar.
2. Carefully unpack your new fixture and
lay out all the parts on a clear area. Be
careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3.
4.
Remove the mounting screws (C) and thumb
screws (D) from the fixture. Loosen the wire
connector (B) on the IC components output
line, and remove the canopy and back plate.
Carefully put the textured glass into the
fixture frame.
NOTE: The textured side must face out.
CONNECTING THE WIRES (Fig. 2)
9. Connect the IC components' input wires with junction box wires as shown (Fig. 2). Make sure that all wire connectors (A) (B) are secure.
If
your outlet box has a green or bare copper ground wire, connect the Axture’s ground wire to it. Otherwise, connect the Axture’s ground
wire directly to the mounting plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
10. Place the fixture over the back plate and secure it with mounting screws (C)
Junction Box
C
Thumb
Screw
D
E
A
F
Wood Screw
B
Back Plate Dimensions
Back Plate
Canopy
F