Installation Sheet
3
INSTALLATION INSTRUCTIONS
WS-34119/WS-34125/WS-34137
Phone (800) 526.2588
Fax (800) 526.2585
44 Harbor Park Drive
Port Washington, NY 11050
1600 Distribution Ct
Lithia Springs, GA 30122
1750 Archibald Avenue
Ontario, CA 91760
1.
2.
Black or
Smooth
White or
Ribbed
Bare wire
(Ground)
Black
(Hot)
White
(Neutral)
Green or Bare Copper
(Ground)
4 1/2"
6"
1 3/8"1 5/8"
(Fig. 1)
3.
6.
Connect the driver input wire to switch box wires as shown in
4.
The lamp can switch between three color temperatures(2700k-3000k-3500k), which can be adjusted to your preference with the switch in the
canopy (Fig.4).
4.
The lamp can switch between three color temperatures(2700k-3000k-3500k), which can be adjusted to your preference with the switch in the
canopy (Fig.4).
Fig. 5 , making sure that all wire connectors (A) are secured.
wire directly to the back plate using the GND screw provided. After wires are connected, tuck them carefully inside the switch box.
5.
Secure the mounting plate to the switch box using the junction box screws (C). The side of the mounting plate marked
"GND" must face out.
7.
First, loosen both adjustable nuts by turning counterclockwise.
as shown in Fig3.
as shown in Fig3.
Second, adjust the back plate to your desired location.
Third, pull and tighten the electrical wire.
Lastly, secure the back plate by turning both adjustable nuts clockwise.
8.
(Fig. 2)
3.
6. Connect the driver input wire to junction box wires as shown in Fig. 5 , making sure that all wire connectors (A) are secured.
wire directly to the back plate using the GND screw provided. After wires are connected, tuck them carefully inside the junction box.
5. Secure the mounting ring (D) to the junction box using the junction box screws (C). Make sure the two holes (Spacing 2-3/4") are horizontal
as shown in Fig. 2 . The side of the mounting plate marked "GND" must face out.
7. Secure the mounting plate and conversion plate (E) to the mounting ring(D) with assembly screw (F).
8.
First, loosen both adjustable nuts by turning counterclockwise.
Second, adjust the back plate to your desired location.
Third, pull and tighten the electrical wire.
Lastly, secure the back plate by turning both adjustable nuts clockwise.
9.