Installation Guide

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modernforms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAY, 2014
INSTALLATION INSTRUCTION
Polar
WS-3226
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary
for installation.
3. Remove screws (L1) from the xture.
CONNECTING THE WIRES (Fig. 2)
3. Remove screws (C1) from the xture.
4. Connect the electrical wires as shown in Fig, 2, making sure that all wire connectors are secured. If your outlet box has a green
or bare copper ground wire (N1), connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to
the back plate (D1) using the green screw (E1) provided. After wires are connected, tuck them carefully inside the junction box.
*Requires Transformer to be recessed within the junction box
MOUNTING THE FIXTURE (Fig. 1)
5. Secure mounting backplate (D1) to the junction box (F1) using junction box screws (B1).The side of the mounting backplate
marked “GND” (E1) must face out
6. Secure the mounting backplate (D1) to wall using the screws (I1) and the plastic anchors(J1).
7. Connect the xture’s blue and red wires to the transformer’s red output wires; blue to red; red to the other red.
Use wire connectors (S1).
8. Place the xture back plate (K1) over the mounting backplate (D1)
and secure with screws (L1).
9. Place the pc shade (P1) onto the xture to cover the led.
COMPLETING THE INSTALLATION (Fig. 1)
10. Install the glass (G1) on the glass holder (Q1) with screws (O1)
and plastic washers (R1).
11. Secure the glass holder into the xture back plate (K1)
and secure with mounting screw (C1).
FIG.2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare Copper
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
K1
D1
S1
A1
F1
N1
M1
J1
E1
B1
I1
H1
L1
P1
O1
R1
C1
Q1
G1
FIG.1