Installation Sheet
Table Of Contents
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
3. Remove the mounting screw (B) and mounting plate from the xture.
4. Secure the mounting plate to the junction box using standard junction box screws that comes with the junction box
.
(i)using any other non-original-manufacturer provided junction box screw may result in safety issue;
(ii) The side of the mounting plate marked “GND” must face out.
5. Connect the driver’s input wires to junction box wires as shown (Fig. 2). Make sure that all wire connectors (A) are secure. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
back plate using the GND screw provided. After wires are connected, tuck them carefully inside the junction box.
6. Secure the xture to the mounting plate using the mounting screw (B).
Black or
Smooth
White or
Ribbed
Bare wire
(Ground)
Black
(Hot)
White
(Neutral)
Green or Bare Copper
(Ground)
2
INSTALLATION INSTRUCTIONS
WS-32128
Phone (800) 526.2588
Fax (800) 526.2585
44 Harbor Park Drive
Port Washington, NY 11050
1600 Distribution Ct
Lithia Springs, GA 30122
1750 Archibald Avenue
Ontario, CA 91760
1 3/8"
1 3/4"
7 5/8"
4 1/8"
Mounting Screw
Mounting Plate
B
Junction Box
Wire Connector
A
Lamp Shade
Fixture
Driver(3 1/2"Lx3 3/8"Wx5/8"L)