Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MARCH, 2016
INSTALLATION INSTRUCTION
Vogue
WS-3120
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove screws (C1) from the xture and remove Connectors (A1).
4. Connect the xture wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured.
Fixture and junction box ground wires should be connected to mounting plate using green screw provided. After wires are connected,
tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
5. Secure mounting backplate (D1) to the junction box
using junction box screws (B1).
The side of the mounting backplate marked “GND” must face out.
6. Place the xture’s canopy plate (L1) over the mounting back plate (D1)
and secure with screws (C1).
7. Slide the glass shade (G1) onto the front bracket (M1).
8. While supporting the glass, attach glass holders (H1) to
the front bracket with screws (N1) to secure the glass in place.
I1
A1
D1
B1
C1
M1
L1
N1
H1
G1
Junction Box
Ground Wire
Wire Connector
Mounting Backplate
Junction Box Screw
Canopy Plate
Screw
Front Bracket
Glass
Glass Holders
Fixture Screw
Fixture output wires - Red
Blue xture wire
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
4 1/8”
1 3/8”
6 3/8”
1 3/4”
WS-3120/WS-3127 Back Plate Dimensions