Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including mounting hardware.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary
for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove screws (C1) from the xture. Remove wire connectors (A1).
4. Connect the xture wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are
secured. Fixture and junction box ground wires should be connected to mounting plate using green screw provided.
After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
5. Secure mounting backplate (D1) to the junction box (F1) using junction box screws (B1).
The side of the mounting backplate marked “GND” must face out.
6. Place the xture’s canopy plate (L1) over the mounting
back plate (D1) and secure with screws (C1).
7. Slide the glass (G1) into the front bracket (H1) and
secure with the clips (I1).
INSTALLATION INSTRUCTION
Vogue
WS-3111, WS-3115
FIG.1
M1
F1
A1
B1
D1
L1
C1
Junction Box
Ground Wire
Wire Connector
Junction Box Screw
Mounting Backplate
Fixture output wires - Red
Blue Fixture Wire
Canopy Plate
Fixture Screw
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring