Installation Sheet

2
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company’s continuous improvement program.
INSTALLATION INSTRUCTION
308 – LED Wall Sconce
WS-30815
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Rubbed
Fixture Wires
Bare Wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
4⁄”
4⁄”
1¾”
1⁄”
FIG.1
MOUNTING BACK PLATE
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
3. Remove the mounting screw (C) from the mounting back plate.
4. Insert the crystal into the xture; secure it with Allen screws (D) using Allen wrench (E). And make sure it unshakeable.
5. Secure the mounting back plate to the junction box using junction box screws (B), the side of the mounting back plate marked
“GND” must face out.
CONNECTING THE WIRES (FIG. 2)
6. Connect the driver input/output wires to junction box wires as shown in Fig. 2. Making sure that all wire connectors (A) are secured.
If your outlet box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground
wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
* Requires Driver to be recessed within the junction box.
COMPLETING THE INSTALLATION (FIG. 1)
7. Secure the xture to the mounting back plate using the mounting screw (C).
Crystal
(RPL-GLA-30815)
Allen Screw Allen Wrench
Junction Box Screw
Mounting Back Plate
Fixture
Mounting Screw
Junction Box
Wire Connector
Driver
2w”L x 14”W x 18”H
D E
B
C
A
G0