Installation Sheet

2
INSTALLATION INSTRUCTIONS

WS-26222
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. Nov. 2021
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
3000K3500K 2700K
FIG. 3
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
FIG. 2 Wiring
7 7/8"
WS-26222 Mounting Back Plate
1 3/8"
1 3/4"
4
7/8"
5 1/2"
White Fabric Shade
(RPL-SHA-26222)
Decorative Frame
Bottom diffuser
(RPL-DIF-26222-02)
Bottom screw
C
Wood Screw
E
Wire Connector
A
Mounting screw
B
Mounting Back plate
Junction Box Screw
Plastic Anchor
F
Junction Box
Switch
Top diffuser
(RPL-DIF-26222-01)
Top screw
D
Fixture
FIG. 1
Allen Screw
Allen Wrench
I
H
Wood Screw
Support Column
G
E
Plastic Anchor
F

1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.

3. Remove the mounting screw (B) and back plate from the xture.
4. The lamp can switch between three color temperatures (2700K-3000K-3500K), which can be adjusted to your preference with the switch in
the canopy (Fig.3).
5. Remove the bottom screw ( C ) and top screw (D), fasten the bottom diuser between the xture and decorative frame using bottom screw
( C ),loose the allen screw (H) using allen wrench (I).
6. Drill holes in the wall aligned with the key holes located in the mounting back plate and the decorative frame .
Secure the mounting back plate to the junction box using standard junction box screws that comes with the junction box, fasten it to the wall
using wood screw (E) .
Note  (i) using any other non-original-manufacturer provided junction box screw may result in safety issue;
(ii) The side of the mounting plate marked “GND” must face out.

7. Connect the xture’s wires to junction box wires as shown in , making sure that all wire connectors () are secured. If your outlet box has
a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the back
plate using the GND screw provided. After wires are connected, tuck them carefully inside the junction box.

8. Insert the plastic anchor (F) and ax the support column (G) to the lower plastic anchor(F) using wood screw (E).
9. Secure xture to back plate with mounting screw (B) . Ensure the support column is aligned and inserted into the frame's lower support arm.
10. Place the fabric shade over the xture so it sits on the notch of the xture, secure the top diuser by fastening the top screw (D) .
11. Secure the frame’s lower support arm to the wall so it is ush by tightening the allen screw (H) using allen wrench (I).