Installation Sheet

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. 2
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Secure the heat sink to the glass shade using the mounting screw (C).
MOUNTING THE FIXTURE (Fig. 2)
4. Remove the mounting screw (D) from the mounting back plate.
5. Drill holes in the wall aligned with the key hole located in the mounting plate, insert the plastic anchor (E).
6. Secure the mounting back plate to the junction box using junction box screws (B), fasten it to the wall using wood screws (F). The side of
the mounting back plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 3)
7. Connect the xture’s wires to junction box wires as shown in Fig. 3, making sure that all wire connectors (A) are secured. If your outlet
box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly
to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
COMPLETING THE INSTALLATION (Fig. 2)
8. Secure the xture to the mounting back plate using the mounting screw (C).
INSTALLATION INSTRUCTION
258 – LED Wall Sconce
WS-25827/WS-25827F/WS-25837/WS-25837F
C
E
F
D
C
A
Mounting Screw
Plastic Anchor
Wood Screw
Mounting Screw
Junction
Box Screw
Wire
Connector
Junction Box
Ground Wire
Fixed Aluminium
Ground
Wire Screw
Heat Sink
Glass
(RPL-GLA-25827/RPL-GLA-25837)
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 3 Wiring
FIG 1.
FIG 2.
BACK PLATE DIMENSIONS
4”
1 3/4”
1 3/8”
WS-72527 19 7/8”
WS-72527 25 3/8”
WS-72537 23 7/8”
WS-72537 35 3/8”